£100.00 / day£400.00 / week
This smooth running mechanism runs on steel bearings and allows the rails of the slider to move with the camera when mounted on a tripod, which gives 700mm of slider travel, although it is only 537mm in length, weighs only 2.14kg and comes in a pouch small enough to fit inside a suitcase!
This version includes a full timelapse kit with pan or tilt head and cables to control Sony/Canon DSLR cameras timelapse shooting function.
Note that the payload capacity of the timelapse target module is suitable only for DSLR cameras.
Non timelapse version of slider
Two Axis timelapse version of slider
Three Axis timelapse version of slider (no focus)
Four Axis timelapse version of slider including time-lapse Focus Control
Its compact sizes makes it ideal for travel, as it takes of up less room in your camera bag than other sliders with a similar sliding range and it supports loads of upto 12kg, so it is suitable for C300, FS-700 etc and other small cameras.
The tracking system works by having two thin bands that are connected to each side of the mounting plate and base plate. When placed on a flat surface, the base plate travels in the opposite direction of the mounting plate. This will yield results of traditional slider. To take advantage of the design, the SliderPLUS needs to be mounted to a tripod. When mounted on a tripod, the movement of the base plate is restricted, causing the rails to move through the base plate in the same direction as the mounting plate.
With traditional sliders, you’re often limited to the amount of dolly in/out you can do, because the slider itself usually will end up in the shot eventually. With the SliderPLUS, the rails are also retracting backwards with the camera, allowing for longer dolly in/out shots. A lock mechanism can be engaged to keep the slider from moving if the tripod becomes unlevel.
The slider provides a 3/8″-16 threaded hole at the bottom of the base plate for attaching to a tripod and we supply this system with a lightweight Manfrotto head without charge, so that you can operate pan and tilt as well as slide.
This is a terrifically elegant system which has 2 x removable modules which when fitted allow:
Note that if the slider needs to have the belt replaced for a geared belt if being used in time lapse mode. Damage will be done to the system if manual control of the slider is used with the geared belt in place, so this needs to be either configured for manual or time lapse use. 4 x allen keys are needed to be undone for the belt to be replaced,
Peli case Edelkrone Motion Control 35 x 48 x 17 8.4kg
Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website. These cookies do not store any personal information.
Any cookies that may not be particularly necessary for the website to function and is used specifically to collect user personal data via analytics, ads, other embedded contents are termed as non-necessary cookies. It is mandatory to procure user consent prior to running these cookies on your website.